ECS A790GXM-A Manual page 25

WOL1: Wake On LAN connector (optional)
If you have installed a LAN card, use the cable provided with the card to plug into the
WOL connector onboard. This enables the Wake On LAN (WOL) feature. When
your system is in a power-saving mode, any LAN signal automatically resumes the
system. You must enable this item using the Power Management page of the Setup
Utility in the BIOS. See Chapter 3 for more information.
Pin Signal Name
1
5VSB
2
GND
3
Ring#
Installing the Motherboard
Function
+5V stand by power
Ground
Wake up signal (low active)
21