Removing The Swivel Neck; Removing The Swivel Neck Cover; Changing The Electronic Controller - Windsor versamatic 14 Operating Instructions Manual

Maintenance
36
37
38
34
X
34
14
35
37
36
39
X
86404570 VERSAMATIC 14 & 18 120V

Removing The Swivel Neck

To remove the swivel neck (35) remove the two small
screws (36) from the swivel neck supports (37) then
lift the swivel neck assembly from the chassis.
NOTE: On re-assembly ensure that the wires from
the swivel neck are not trapped when the power
head cover is replaced.

Removing The Swivel Neck Cover

Remove the retaining screw (38), slide the cover (39)
downwards then lift out.
NOTE: On re-assembly check that the leads do not
become trapped.

Changing The Electronic Controller

Disconnect the lead from the motor. Lift the controller
(34) upwards from the motor. Lift the controller
upwards from the swivel neck.