Denon DVD-A11 Operating Instructions Manual page 9

Dvd audio-video/super audio cd player
Hide thumbs Also See for DVD-A11:
Table of Contents

Advertisement

(5) Connecting a basic 5.1-channel surround system
Analog 5.1-channel audio signals can be output from the DVD-A11.
The multichannel audio signals recorded in packed PCM and the multichannel Super audio CDs can be played
when an AV amplifier equipped with analog 5.1-channel audio inputs is connected.
DVD-A11
Front speaker (left)
Surround speaker (left)
DIRECT
PHONES
INPUT
MODE
AV amplifier with 5.1-channel
NOTES:
• For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI
CHANNEL" and make the "SPEAKER CONFIGURATION", "CHANNEL LEVEL" and "DELAY TIME" settings.
(See pages 19, 20.)
• With the DVD-A11, we recommend turning the digital output off and only outputting analog signals in order
to keep interference from the digital output circuitry to the minimum and allow you to enjoy high bit, high
sampling frequency, high quality multi-channel sound.
To power outlet
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (right)
SURROUND MODE
MULTI FUNCTION
DOLBY
DTS
WIDE
5CH / 7CH
DSP
MODE
FUNCTION
CONTROL
STEREO
SURROUND
SURROUND
SCREEN
STEREO
SIMULATION
STATUS
SELECT
CINEMA /
6.1 / 7.1
VIDEO
TONE
REC /
ANALOG
EXT. IN
MUSIC
SURROUND
ON / OFF
DEFEAT
M-ZONE 1
M-ZONE 2
INPUT
REC SELECT / M-ZONE
input terminals
(6) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 20.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1 kHz / 48 kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-A11
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record
Super Audio CDs.
(7) Connecting to a Stereo Component
DVD-A11
NOTE:
• When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at
"SETUP" to "2 CHANNEL" (see page 19). For multi-channel sources, the signals are down-mixed into two
channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
B
Digital audio input
connector (OPTICAL)
Optical fiber cable (commercially available)
(or)
75 Ω/ohms pin-plug cable (commercially available)
Stereo component
ENGLISH
8
9
Digital audio
input
connector
(COAXIAL)
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents