Denon DVD-A11 Operating Instructions Manual page 8

ENGLISH
(4) Connecting to a AV amplifier with a Built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from
the DVD player's digital audio output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve
sound with the power and sense of presence of a movie theater or concert hall.
DVD-A11
Front speaker (left)
75 Ω/ohms
pin-plug cable
(commercially
available)
Digital audio
input connector
(COAXIAL)
Surround speaker (left)
AV amplifier with a built-in decoder
NOTES:
• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS
is played while using a decoder, etc., that is not DTS-compatible.
• When playing copyright-protected linear PCM or packed PCM DVDs, in consideration of copyrights, no digital
signals are output for sources exceeding 48 kHz/16 bits. When playing such sources, either set "LPCM
(44.1 kHz/48 kHz)" under "AUDIO SETUP" at "SETUP" to "ON" (see page 20) or make analog connections.
(See page 9.)
• When making digital connections to an AV amplifier that is not compatible with 96 kHz/88.2 kHz signals, set
"LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at "SETUP" to "ON". (See page 20.)
• With Super audio CDs, digital audio signals cannot be output. Use analog connections. (See page 9.)
2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)
Dust cap Line up in proper direction
Remove the dust cap, line up the cable in the proper
directly, then insert it securely as far as it goes.
8
To power outlet
Center speaker
Front speaker (right)
Optical fiber cable
(or)
(commercially
available)
Digital audio input
Subwoofer
connector
(OPTICAL)
Surround speaker (right)
SURROUND MODE MULTI FUNCTION
DIRECT STEREO DOLBY SURROUND SURROUND DTS SCREEN WIDE 5CH / 7CH STEREO SIMULATION DSP STATUS SELECT MODE FUNCTION CONTROL
PHONES
MODE INPUT ANALOG EXT. IN CINEMA / MUSIC 6.1 / 7.1 SURROUND ON / OFF VIDEO DEFEAT TONE M-ZONE 1 REC / M-ZONE 2
INPUT REC SELECT / M-ZONE
(AV control center)
NOTE:
• Store the dust cap in a safe place, and be careful
not to lose it.
When not using the terminal, attach the cap to
protect the terminal from dust.
Sound output from the DVD-A11's digital audio output connectors
2
In the case of bit stream output
Audio recording format
Dolby Digital Dolby Digital bitstream
DVD video DTS
MPEG Audio
In the case of PCM output
Audio recording format
Copy protection ON
48 kHz / 16 ~ 24 bit No output data (*1)
DVD Linear
video PCM
96 kHz / 16 ~ 24 bit No output data
44.1 kHz / 16 ~ 24 bit No output data (*2)
48 kHz / 16 ~ 24 bit No output data (*1)
88.2 kHz / 16 ~ 24 bit No output data
DVD
audio
96 kHz / 16 ~ 24 bit No output data
176.4 kHz / 16 ~ 24 bit No output data
192 kHz / 16 ~ 24 bit No output data
Video CD MPEG 1
Music CD 44.1 kHz / 16 bit Linear PCM
MP3 CD MP3 (MPEG-1 Audio Layer 3)
WMA CD WMA (Windows Media Audio)
Super
DSD (DIRECT STREAM DIGITAL)
audio CD
*1 Only 48 kHz/16 bit sources are output.
*2 Only 44.1 kHz/16 bit sources are output.
*3 44.1 kHz/16-bit PCM signals are output during CD layer playback.
• Down-mixed to 2 channels for multi-channel PCM sources. (Only the front left and right channels are output for
sources for which down-mixing is prohibited.)
• When "OFF" is selected, digital signals are not output from the digital audio output at this time.
• Bitstream signals are signals that are compressed and converted into digital format. They are decoded into
multi-channel audio signals (5.1-channels, etc.) by the decoder.
• Linear PCM audio is a signal recording format used for music CDs.
While signals are recorded at 44.1 kHz/16 bit for music CDs, for DVDs they are recorded at 44.1 kHz/16 bit to
192 kHz/24 bit, providing higher sound quality than music CDs.
• Packed PCM signals are high sound quality compressed PCM signals that are decompressed with virtually no
loss of data.
Settings
DIGITAL OUT
NORMAL PCM
2 channels PCM
(48 kHz / 16 bit)
2 channels PCM
DTS bitstream
(48 kHz / 16 bit)
2 channels PCM 2 channels PCM
(48 kHz / 16 bit) (48 kHz / 16 bit)
Settings
LPCM SELECT
OFF
Copy protection OFF
48 kHz / 16 ~ 24 bit PCM 48 kHz / 16 bit PCM
96 kHz / 16 ~ 24 bit PCM 48 kHz / 16 bit PCM
44.1 kHz / 16 ~ 24 bit PCM 44.1 kHz / 16 bit PCM
48 kHz / 16 ~ 24 bit PCM 48 kHz / 16 bit PCM
88.2 kHz / 16 ~ 24 bit PCM 44.1 kHz / 16 bit PCM
96 kHz / 16 ~ 24 bit PCM 48 kHz / 16 bit PCM
88.2 kHz / 16 ~ 24 bit PCM 44.1 kHz / 16 bit PCM
96 kHz / 16 ~ 24 bit PCM 48 kHz / 16 bit PCM
44.1 kHz / 16 bit PCM 44.1 kHz / 16 bit PCM
44.1 kHz / 16 bit PCM 44.1 kHz / 16 bit PCM
44.1, 48 kHz / 16 bit PCM 44.1, 48 kHz / 16 bit PCM
44.1, 48 kHz / 16 bit PCM 44.1, 48 kHz / 16 bit PCM
No output data (*3) No output data (*3)
ON