Panasonic S-12MU1U6 Installation Instructions Manual page 66

CAUTION
When connecting each power wire to the terminal, follow
the instructions on "How to connect wiring to the terminal"
and fasten the wire securely with the fi xing screw of the
terminal plate.
How to connect wiring to the terminal
■
For stranded wiring
(1) Cut the wire end with cutting pliers, then strip the
insulation to expose the stranded wiring approx. 3/8 in.
and tightly twist the wire ends. (Fig. 4-4)
(2) Using a Phillips head screwdriver, remove the terminal
screw(s) on the terminal plate.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring pressure
terminal.
(4) Place the ring pressure terminal, and replace and
tighten the removed terminal screw using a
screwdriver. (Fig. 4-5)
VRF_Indoor_US.indb 66 VRF_Indoor_US.indb 66
Loose wiring may cause the
terminal to overheat or result
in unit malfunction. A fi re
hazard may also exist.
Therefore, ensure that all
wiring is tightly connected.
Stranded wire
Fig. 4-4
Special
Screw
washer
Ring pressure
terminal
Terminal plate
Wire
Fig. 4-5
66
Ring
pressure
terminal
Screw and
Special washer
Ring
pressure
terminal
Wire
2011/09/30 12:23:12 2011/09/30 12:23:12