Panasonic S-12MU1U6 Installation Instructions Manual page 27

Removing the intake grille
Slide the intake grille hooks (2
locations) in the direction of the
arrow to open the intake grille.
(Fig. 3-72)
When the intake grille is open, press
a fl athead screwdriver against the
rear tabs (2 locations) and pull out
the intake grille. (Fig. 3-73)
Removing the side panel
Grasp the fi nger grip on the side
panel and slide the panel in the
direction of arrow 1 to remove the
panel. (Fig. 3-74)
(There are 2 panels: 1 each on the
left and right sides.)
1 Slide
Side panel
3-19-2. Installing the ceiling panel
(1) Fasten the hooks on both sides of the ceiling panel
to the indoor unit. The hooks on one side
(2 locations) are stationary, while the hook on the
other side is moveable. (Fig. 3-75)
(2) Angle the panel somewhat and fasten the stationary
hook into the fastener on the side of the unit.
(3) After verifying that the hook is fastened, press the
other end up until the ceiling panel is level. Then
press upwards until the moveable hook is fastened
into the fastener on the unit.
(4) Verify that the hooks on both sides of the ceiling
panel are securely fastened to the unit. If the hooks
are not securely fastened, the panel may fall. At this
point, the panel is now provisionally fastened to the
unit.
●
When removing the panel, press the movable hook
toward the inside while supporting the panel.
(Fig. 3-76)
VRF_Indoor_US.indb 27 VRF_Indoor_US.indb 27
Fig. 3-72
Fig. 3-73
Press on the tabs with a flathead (minus)
screwdriver while pulling out the intake grille.
Tab
Fig. 3-74
Screw
Screw
Hook
Hinge
Stationary hook
Fig. 3-75
27
Intake grille
Hook receiver Press to remove.
Moveable hook
Fig. 3-76
Moveable hook
2011/09/30 12:23:07 2011/09/30 12:23:07