Suspending The Indoor Unit - Panasonic S-12MU1U6 Installation Instructions Manual

Vrf system
Hide thumbs Also See for S-12MU1U6:
Table of Contents

Advertisement

3-31. Suspending the Indoor Unit

Depending on the ceiling type:
• Insert suspension bolts as shown in the diagram
or
• Use existing ceiling supports or construct a suitable
support as shown in the diagram.
WARNING
(1) When placing the unit inside the ceiling, determine the
pitch of the suspension bolts referring to the
dimensional data on the previous page. Tubing must
be laid and connected inside the ceiling when
suspending the unit. If the ceiling is already
constructed, lay the tubing into position for connection
to the unit before placing the unit inside the ceiling.
(2) Screw in the suspension bolts allowing them to
protrude from the ceiling as shown in the diagram.
(Cut the ceiling material, if necessary.)
(3) Thread the 3 hexagonal nuts and 2 washers (fi eld
supply) onto each of the 4 suspension bolts as shown
in the diagram. Use 1 nut and 1 washer for the upper
part, and 2 nuts and 1 washer for the lower part, so
that the unit will not fall off the suspension lugs.
Suspension bolt
Hexagonal nut
Double nuts
(4) Adjust the height of the unit.
(5) Check the unit is horizontally level.
CAUTION
Make sure the unit is installed level using a level or
a plastic tube fi lled with water. In using a plastic
tube instead of a level, adjust the top surface of the
unit to the surface of the water at both ends of the
plastic tube and adjust the unit horizontally. (One
thing to watch out for in particular is if the unit is
installed so that the slope is not in the direction of
the drain piping, this might cause leaking.)
(6) Tighten the upper nut.
VRF_Indoor_US.indb 38
VRF_Indoor_US.indb 38
It is important that you use
extreme care in supporting the
indoor unit inside the ceiling.
Ensure that the ceiling is
strong enough to support the
weight of the unit. Before
hanging the unit, test the
strength of each attached
suspension bolt.
Fig. 3-109
Hole-in-anchor
Hole-in-plug
Suspension bolt (M10 or 3/8")
Fig. 3-107
Fig. 3-108
Nuts and washers
(use for upper and lower)
Double nuts
Fig. 3-110
Level gauge
Fig. 3-111
38
Concrete
Insert
Ceiling tiles
Ceiling support
Suspension bolt
Suspension lug
Notch
Vinyl tube
2011/09/30 12:23:08
2011/09/30 12:23:08

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents