Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific RGR202 User Manual

3. RAIN ALERT : Toggle between rain alert / enable
alert / disable alert; enter rain alert setting mode
4. IN / MM : Select rainfall unit
REMOTE SENSOR (FIG. 3)
1
. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch

GETTING STARTED

INSERT BATTERIES

. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see
FIG 2).
2
4
3
5
3. Press RESET after each battery change.
LOCATION
Clock area
Outdoor temperature Sensor batteries low
and humidity area
Rainfall area

REMOTE SENSOR

To set up the sensor:
. Open the battery compartment (see FIG 3).
2. Select Channel  then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than .5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
3
MEANING
Main unit batteries low
Rain collector sensor
batteries low