Lens Installation - Sanyo PLC-WM5500 Service Manual

Maintenance

Lens Installation

When replacing the lens or using an optional lens, install the lens by following the instructions below.
Removing the lens
1
Shift the lens to the center position by using the
Lens shift function.
2
Turn off the projector and unplug the AC power
cord.
3
While pressing the Lens release button on the top
of the cabinet, turn the lens counterclockwise until
it stops and pull it out slowly from the projector.
CAUTION
Be careful when handling the lens. Do not
drop.
Attaching the lens to the projector
1
Remove the lens mount cover.
2
Fit the lens to the projector by aligning the red dot
on the lens with the red dot of the projector.
3
Slowly turn the lens clockwise until it clicks. Make
sure that the lens is fully inserted to the projector.
CAUTION
Do not press the lens release button when at-
taching the lens.
-14-
Lens Release button
Red dots