Lamp Replacement - Sanyo PLC-WM5500 Service Manual

Maintenance

Lamp Replacement

When the projection lamp of the projector reaches its end of life,
the Lamp replacement icon appears on the screen and LAMP
REPLACE indicator lights. Replace the lamp with a new one
promptly. The timing when the LAMP REPLACE indicator should
light is depending on the lamp mode.
Note:
The Lamp replacement icon will not appear when the Display
function is set to "Off", or during "Freeze".
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord. Let the
projector cool for at least 45 minutes.
2
Loosen the screw and slide the lamp cover to open it.
3
Loosen 3 screws of the lamp and pull out the lamp by using
the built in handle.
4
Replace the lamp with a new one. Make sure that the lamp
is properly and fully inserted.
5
Close the lamp cover and secure the screw.
CAUTION
When replacing the lamp because it has stopped illuminating,
there is a possibility that the lamp maybe broken. If replacing the
lamp of a projector which has been installed on the ceiling, you
should always assume that the lamp is broken, and you should
stand to the side of the lamp cover, not underneath it. Remove
the lamp cover gently. Small pieces of glass may fall out when
the lamp cover is opened. If pieces of glass get into your eyes or
mouth, seek medical advice immediately.
For continued safety, replace with a lamp of the same type lamp.
Do not drop the lamp or touch the glass bulb! The glass can shat-
ter and may cause injury.
CAUTION
Allow a projector to cool for at least 45 minutes before you open
the Lamp cover. The inside of the projector can become very
hot.
ORDER REPLACEMENT LAMP
Model
Type No.
Service Parts No.
PLC-WM5500/PLC-WM5500L
POA-LMP136
610 346 9607
Top Panel
Lamp cover
Lamp
New Lamp
-11-
Lamp replacement icon
LAMP REPLACE indicator
Handle