AMX NXD-1200V Operation/Reference Manual page 115

System Settings Page Elements
Back:
Connection Status icon:
IP Settings:
DHCP/Static
IP Address
Subnet Mask
Gateway
Host Name
Primary DNS
Secondary DNS
Domain
Ethernet Mode
MAC Address
Master Connection:
Type
NXD/T-1200V Wall/Flush Mount Touch Panel
Saves the changes and returns you to the previously active touch panel page.
This visual display of the connection status allows the user to have a current visual update
of the panel's connection status regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection with a
currently secured target Master (requiring a username and password).
Sets the IP communication values for the panel and contains:
Sets the panel to either DHCP or Static communication modes.
• DHCP (Dynamic Host Configuration Protocol) assigns IP Addresses from client
stations logging onto a TCP/IP network via a DHCP server.
• Static IP is a permanent IP Address that is assigned to a node in a TCP/IP network.
Sets the secondary IP Address assigned to the panel.
Sets a subnetwork address to the panel.
• Subnetwork mask is the technique used by the IP protocol to filter messages into a
particular network segment (Subnet).
Sets a gateway value to the panel.
• Gateway is a computer that either performs protocol conversion between different
types of networks/applications or acts as a go-between two or more networks that
use the same protocols.
Sets the host name of the panel.
Sets the address of the primary DNS server used for host name lookups.
• DNS (Domain Name System) is software that lets users locate computers on a local
network or the Internet (TCP/IP network) by host and domain. The DNS server
maintains a database of host names for its' domain and their corresponding IP
Addresses.
Sets a secondary DNS value to the panel.
Sets the unique name on the Internet to the panel for DNS look-up.
• The panel belongs to the DNS domain.
Sets the speed of the Ethernet connection to the panel.
• Choices are: Auto, 10 Half Duplex, 10 Full Duplex, 100 Half Duplex, or
100 Full Duplex.
Displays a read-only field that is factory set by AMX for the built-in Ethernet interface.
Sets the NetLinx Master communication values:
Sets the NetLinx Master to communicate with the panel via either USB or Ethernet. This is
based on the cable connection from the rear.
ICSNet is not a supported option on this panel.
• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector) used to
network computers together and is used in most LAN (local area networks). This
description is also used to refer to both wired and wireless communication.
• USB option cannot be used on Modero panels which are not equipped with a rear
USB port.
Firmware Pages and Descriptions
103