BASIC ENGINE PARTS
Heatsink Head
Carburettor
Typr 60B
Propeller nut
Drive Hub
Crankshaft
Glowplug
Cover Plate
Beam Mount
Crankcase
61SX-H
"WC"
MAX-
RING
INSTALLING THE GLOWPLUG
Install the washer on the
glowplug
and
carefully into cylinder-
head, making sure that it
is
not
cross-threaded
before tightening firmly.
INSTALLATION OF THE CARBURETOR
As delivered, the engine has its carburetor lightly
fitted into its intake boss. Secure it as follows.
1.
Loosen the retainer screw, rotate the carburetor to
its correct position and press it well down into the
intake boss, compressing the rubber gasket as
shown in the sketch, before re-tightening screw.
2.
Rotate the retainer screw gently until it stops, then
tighten a further 120-180 degrees. Do not over-
tighten the screw as this will damage the thermo-
insulator.
Retainer
screw
Positioning Mark
7
screw
Glow plug
Washer
0.2mm gap
Carburetor Rubber
Gasket