Telnet Command: Ip6 Neigh - Draytek Vigor2860 Series User Manual

-p <password>
-s <server>
-d <server>
-D <server>
-t <dhcp/ra/none>
-V
-o
E x a m p l e
E x a m p l e
> ip6 internet -W 2 -M 2 -u 88886666 -p draytek123456 –s
amsterdam.freenet6.net
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> system reboot
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to display IPv6 neighbour table.
ip6 neigh -s[ inet6_addr] [eth_addr] [LAN|WAN1|WAN2]
ip6 neigh -d [inet6_addr] [LAN|WAN1|WAN2]
ip6 neigh -a [inet6_addr] [-N LAN|WAN1|WAN2]
S y n t a x D e
S y n t a x D e
Parameter
It means to set Password.
<password> = type a password (maximum 63
characters).
It means to set Tunnel Server IP.
<server>= IPv4 address or URL (maximum 63
characters).
It means to set the primary DNS Server IP.
<server>= type an IPv6 address for first DNS server.
It means to set the secondary DNS Server IP.
<server>= type an IPv6 address for second DNS server.
It means to set IPv6 PPP WAN test mode for DHCP or
RADVD.
<dhcp/ra/none>= type IPv6 address.
It means to view IPv6 Internet Access Profile.
It means to set AICCU always on.
1=On,
0=Off
: i p 6 n e i g h
: i p 6 n e i g h
s c r i p t i o n
s c r i p t i o n
Description
615
Vigor2860 Series User's Guide