Advanced System Functions; Drive Lock / Lgnition Controlled Door Locks; Nd Car Mode (Multiple Vehicle Control); Turbo Timer Mode - Firstech Compustar RF-2W9000FM User Manual

Advanced System Functions

The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local
authorized Firstech dealer to be active.
Drive Lock/Ignition Controlled Door Locks
Tap buttons simultaneously for a half second to turn drive lock on and off (also known as ignition controlled door locks). The
vehicle's parking lights will flash once and/or siren chirp once to confirm drive lock is on. The vehicle's parking lights will flash twice
and/or siren chirp twice to confirm drive lock is off.
IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has three settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: Locks the doors when the RPM's have reached two times that of idle speed (this setting requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual transmission vehicle, the doors will unlock
upon setting the emergency / parking brake.
nd
2 Car Mode (Mulitiple Vehicle Control)
This remote has the ability to operate a 2nd vehicle with the same system. Hold buttons
Option Menu. Your remote will chirp once for on and twice for off. The 2nd Car icon will illuminate confirming that 2nd car mode is
activated. The remote will remain in 2nd Car Mode until you hold the
IMPORTANT: 2nd car mode requires the remote to be programmed to a 2nd vehicle that is equipped with the same RF kit.
By Firstech, LLC 26
FT-2WLCD-S-E_UserGuide.indd 27-28
for 2.5 seconds to enter the Remote
buttons for 2.5 seconds.
Advanced System Functions

Turbo Timer Mode

This feature requires dealer programming and must be turned on with the 2 Way remote. The built in turbo timer keeps the vehicle's
engine running for either 1, 2, or 4 minutes (programmable from dealer) after the vehicle key has been removed from the ignition.
This feature will keep oil running through the turbo system to allow for appropriate cooling time. Tap buttons
for a half second to turn on or off turbo mode. The remote will beep once and the Turbo icon illuminate to confirm that turbo mode is
activated. The remote will beep twice and icon will disappear to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the Firstech system. You must also have working
door pins. Consult your local authorized dealer for installation.
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature and may not be available with your system. Check with your dealer for details. The car call/RPS feature
uses a small sensor that is mounted on the inside of your windshield.
simultaneously
27 By Firstech, LLC
2011-6-10 12:05:46