Operation With Blades - Echo SRM-225 Operator's Manual

SRM-225
Operation of this equipment may create sparks that can start
fires around dry vegitation.This unit is equipped with a spark
arrestor to prevent discharge of hot particles from the
engine. Metal cutters can also create sparks if the cutter
strikes rocks, metal, or other hard objects. Contact local fire
authorities for laws or regulations regarding fire prevention
requirements

Operation With Blades

Blade use DEMANDS specific Brush Cutter configuration.
Operation without specified shield, barrier bar or U-handle, and
harness can result in serious personal injury. Follow installation
instructions.
PARTS REQUIRED FOR THESE BLADES:
Pro Maxi-Cut
Grass/Weed
Blade
Support Handle, w/or
w/o Barrier Bar
Shield w/cutoff knife
Harness
Upper Plate &
Flat Washer
Hex Nut
New Cotter Pin
DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL
TRIMMERS.
• Arbor Diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
X7722279402
© 2/2016 ECHO Inc.
.
Rigid Plastic
Grass/Weed Blade
U-Handle or Support
w/Barrier Bar
Shield w/cutoff knife
Upper Plate
& Glide Cup
New Cotter Pin
Tri-Cut
Handle
Harness
Hex Nut
OPERATION
Metal Blade
U-Handle or Support
Handle
w/Barrier Bar
Shield w/o cutoff knife
Harness
Upper/Lower
Blade Plates
Hex Nut
New Cotter Pin
21