Table of Contents
Advertisement
OPERATION
Operation With Blades
Metal blades are very sharp and can cause severe injuries, even
if engine is off and blades are not moving. Avoid contact with
blades. Wear gloves to protect hands.
Blade use demands specific brush cutter configuration.
Operation without specified shield, barrier bar or U-handle, and
harness can result in serious personal injury. Follow installation
instructions.
Pro Maxi-Cut
Grass/Weed
Blade
Support
Handle, with or
without Barrier
Bar
Shield with
cutoff knife
Upper Plate &
Flat Washer
*ANSI standards require brush cutters be equipped with a barrier bar or
restrictive harness. U-Handle ensures a higher safety factor.
Do Not install blades on GT (Curved Shaft) model trimmers.
• Arbor diameter of upper blade plate must match arbor diameter of blades.
• A new cotter pin is required each time a blade is installed.
• Brushcutters over 7.5 kg (16.5 lbs.) dry weight (without fuel) require a
double shoulder harness.
18
Tri-Cut Grass/
Weed Blade
U-Handle or Support Handle with
Barrier Bar
Shield without cutoff knife
Harness
Upper/Lower Blade Plates
Hex Nut
New Cotter Pin
Metal Grass /
Weed Blade
SRM-2620T
Metal Brush /
Clearing
Blades
U-handle*
X7502341801
© 03/2019 ECHO Inc.
Advertisement
Table of Contents
