Table of Contents
Advertisement
SUPERSERVER 6027TR-DTRF+/D70RF+/D71RF+ User's Manual
5-2
Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
The SuperServer 6027TR-DTRF+ system only has four (4) 29-cm 30AWG SATA
cables (CBL-0483L) used for connecting the SATA hard disk drives to the system.
5-3
Rear I/O Ports
The rear I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-1 below for the colors and locations of the various I/O ports.
1.
2.
3.
4.
5.
6.
7.
Figure 5-1. Rear I/O Ports
1
2
3
I/O Port Locations and Defi nitions
Dedicated IPMI LAN
Gigabit LAN 1
Gigabit LAN 2
USB Port 0
USB Port 1
VGA (Blue)
UID Switch
4
5
6
5-2
7
Advertisement
Table of Contents
