Table of Contents
Advertisement
installation
|
20
OPTIONAL BACKING PLATE INSTALLATION
Optional Backing plate installation
Backing plate installation with spacer
1. Install the spacer to the back of the faceplate backing with 6 screws
from the front of the faceplate backing. 2 screws are also required to
secure the top section of the spacer only.
2. Install the custom backing plate to the faceplate backing and spacer
with 9 screws (3 on each side and 3 across the top) installed from
the backside of the backing plate into the backside of the assembled
faceplate backing with spacer as shown below.
Assembled Faceplate
Backer + spacer
(backside)
3. Proceed to faceplate installation–see faceplate instructions in
manual or with faceplate.
20 |
U32-10 Regency
Direct Vent Gas Insert
®
Spacer
Faceplate backer
(front side)
Backing Plate
(backside)
Backing plate installation without spacer
1. Secure the faceplate backing to the backing plate with 6 screws in
the locations shown below.
Note: Insert the screws from the front side of the faceplate backing
using the inner holes.
Faceplate backer
(front side)
2. Proceed to faceplate installation–see faceplate instructions in
manual or with faceplate.
Backing Plate
Hide quick links:
Advertisement
Table of Contents
