Fujitsu FI-6400 Convenient Operation

f i - 6 4 0 0 / f i - 6 8 0 0 C
f i - 6 4 0 0 / f i - 6 8 0 0 C
1. Setting the Paper Separation Force
If multifeeds, picking errors or paper jams occur
frequently, adjust the paper separation force setting by
using the up and down buttons on the Operator Panel.
(Under normal circumstances, use the default setting
which is 3.)
When multifeeds occur frequently
Increase the paper separation force
(increase it level by level)
When picking errors or paper jams occur
frequently
Decrease the paper separation force
(decrease it level by level)
o n v e n i e n t O p e r a
o n v e n i e n t O p e r a
2. Setting the Stacker Paper Stop and
Stacker Side Guides
Stacker has two paper stops and stacker side guides
located on its each side. By using them efficiently, you
can align the documents more neatly.
Menu Function
/Enter
Send to Clear
Check
/Pause /Back
Stop
Scan
Counter
iMFF Reset Eject
Leave a space of approximately 20 mm
between the paper stop and the largest
document size.
* When scanning A4 and Letter size
documents in landscape orientation, pull out
the Paper Stop to the position shown in the
figure above.
t i o n
t i o n
Adjust the side guides to the
largest document size.
20 mm
* P A 9 3 0 1 2 - Y 8 0 1 *
3. How to place documents of different
widths
The Hopper Side Guides are initially set to slide
symmetrically but if one of the side guides is locked,
the other side guide can be moved separately.
This function is useful when scanning mixed
documents of different sizes.
Side Guide Lock
Unlocked
Make sure to place the documents so that their
entire top edges fit within the width above
(approx. 64 mm).
Locked