Husqvarna Viking Designer Diamond Royale User Manual page 122

8 Embroidery Stitch-Out
Cut thread end
stitches and then stop so you can cut the thread end.
Note: When Automatic Jump Stitch Trim is selected in the SET
Menu, the thread end will be cut automatically. Simply remove the
thread tail that has been cut.
if you wanted to stitch the same embroidery design again,
Raise needle
When the needle is lowered with the handwheel to check
the needle position on the fabric, a pop-up message is
displayed when trying to adjust the hoop position. Check
needle lowered.
Note: Make sure the needle is above the fabric to prevent damage to
the needle and fabric.
Note: The warning cannot be disabled when the needle is below the
stitch plate.
Change to Cutwork Needle (optional accessory)
® Embroidery
Royale
™
stops and this pop-up message is shown, insert the
Note: These cutwork designs can also be stitched out without
the cutwork needles, but that color block will then have to be cut
manually. If cutting manually, go to the next color block in the color
block list when the pop-up appears.
Machine needs to rest
If the machine stops and this pop-up appears on the
enabled you can resume embroidering. The embroidery
results will not be affected.
8:14