Husqvarna Viking Designer Diamond Royale User Manual page 121

8 Embroidery Stitch-Out
EMBROIDERY STITCH-OUT POP-
UP MESSAGES
Embroidery unit calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine
Note: It is very important to remove the hoop, otherwise the hoop or
the embroidery unit may be damaged while calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine will not
size or change the hoop setting to match the hoop size
attached.
The hoop needs to be inserted properly for the machine
attachment from front to back until it clicks into place.
without the selected hoop attached properly.
Bobbin thread low - move to bobbin position?
When the bobbin thread is running low, a pop-up message
plan when you want to change your bobbin. If you want to
the foot control without touching the ok in the pop-up.
It is possible to embroider until the thread has completely
run out. Press the start/stop button to continue
embroidering without closing the bobbin thread low pop-
up. Touch cancel to remain at the current stitch position.
hoop position pop-up opens. Replace the empty bobbin
with a full one. Touch Current position and pull back
excess needle thread. Press start/stop or press your foot
control to continue embroidering.
Check needle thread
The machine stops automatically if the needle thread runs
out or breaks. Re-thread the needle thread, close the pop-
Change thread color
When it is time to change the needle thread, the machine
stops and the upper thread is cut. Change the spool of
thread and re-thread the machine. The next recommended
color number is shown in the pop-up message.
8:13