Advertisement
Fortin EVO-ALL Programming (cont'd):
1. Press and hold the programming button on the EVO-ALL.
2. Insert the 4-pin Data-Link connector that comes with the EVO-ALL into the open 4-pin power on the power
adaptor next to the 2-pin power/ground harness.
3. After the Blue and Red LED's turn on simultaneously, release the programming button.
4. Press and hold the programming button on the EVO-ALL for (5) seconds. The Blue and Red LED's will turn OFF
and back ON after (5) seconds. After the LED's turn back ON release the programming button.
5. Turn the ignition ON. The yellow LED will turn ON.
6. Press the Start button on the REVO-1 or the Lock button on the REVO-4, you may have to hold the button for up
to 3 seconds. The Blue and Red LED's will flash (1) time to confirm that the remote has coded. Repeat this
step for each remote you want coded. You can have up to (4) remotes at a time.
7. Turn the ignition off to exit remote programming.
TRANSMITTER PROGRAMMING
6
Advertisement
