CrimeStopper REVO-1 Series Instructions Manual page 10

Hide thumbs Also See for REVO-1 Series:

POWER ADAPTOR WIRING

NOTE: The power connections are only needed for the EVO-ALL and ADS-ALCA integration modules. The

EVO-ONE will not require these connections. If you are using a T-Harness with the EVO-ONE or ADS modules

then you will NOT need to connect the power and ground connections. If you are NOT using a T-Harness, then you

WILL need to connect the power and ground wires. These wires will supply the power to the module as well as the

REVO antenna.

Connect the Red wire from the 2-pin power adaptor to a 12V constant source.

Connect the Black wire from the 2-pin power adaptor to a paint free, solid metal surface using a crimped on ring

terminal and self-tapping screw. For best results, use a nutsert and bolt.

Table of Contents

Revo-4 series