To Replace the Battering in the REVO 4 Series
The Remote Control uses two CR-2025 Lithium 3 Volt Batteries. Simply remove the Phillips screw located behind
key ring (see diagram below). Use a small screw driver as shown in Figure 2 to remove the back cover. Slide old
batteries out. Insert the new batteries into plastic cover and slide into place with the (+) end facing up. The plastic
cover keeps the batteries from shorting out against the side of metal housing.
ARM /
LOCK
TRUNK
VEH
Fig. 1
BATTERY REPLACEMENT
DISARM /
UNLOCK
START
Back Cover
Vehicle Select
Blue / Red
2 Screws
Slide Key Ring Off
Fig. 2
4
CR2025
Remove
2 Screws &
Fig. 3