Sym MaxSym 600i ABS User Manual page 8

"TIME" Button
a. When the vehicle stands still and the meter shows on "ODO" mode. Press the "TIME" button more than
two seconds to enter the calendar & clock setting mode.
b. When calendar / clock is set up. Press the "SET" button shortly to set up for year, month, date, hour
and minute.
→
YEAR
(FLASHING)
c. Press the "MODE" button shortly to increase the unit digit. Under the clock setting mode, press the
"TIME" button more than two seconds to complete clock setting.
"MODE" Button
a. Press the "MODE" button shortly to switch from odo mode, trip mode and voltage gauge.
TOTAL
CLOCK
b. Engine oil replacement indicator light will illuminate when the vehicle is ridden for approx.
which means the engine oil should be checked or replaced. Key on and press the "MODE" button for at
least two seconds after replacing the engine oil, the engine oil replacement indicator light will extinguish.
"SET" Button
a. Press the "SET" button for at least two seconds under tripmeter mode, the trip mileage can be erased.
b. Key on and press the "SET" button shortly to switch from km & mile mode.
Battery Voltage Display
.
1 Showing the battery voltage.
2. After the main switch is on, the battery voltage will show at least 10 seconds and then clock shows.
CAUTION:

If the battery voltage is below 10.0V when the main switch is on, the light system is off and the engine is
not started, check the battery at SYM dealer.

If the battery voltage is below 10.0V or over 16.0V when the vehicle is moving, check the battery at SYM
dealer.
7. Use of each component
8
→
MONTH
(FLASHING) (FLASHING)
TRIP
CLOCK
→
DATE HOUR
(FLASHING)
TRIP
VOLTAGE
Year / Month / Date
Odometer
Clock / Voltage
→
MINUTE
(FLASHING)
6,000 km,