Panasonic SC-PT450 Operating Instructions Manual page 41

7 Progressive video
There is ghosting when
progressive or HDMI output
is on.
Pictures not in progressive
output.
Closed captions not
displayed.
7 Unit displays
The display is dark.
"NO PLAY"
"NO DISC"
"F61"
"F76"
"DVD U11"
"ERROR"
"DVD H & &"
"DVD F & & &"
& stands for a number.
"U70 &"
& stands for a number.
The actual number following
"U70" will depend on the state
of the main unit.
"REMOTE 1" or "REMOTE 2" • Match the modes on the main unit and remote control. Depending
• This problem is caused by the editing method or material used on
DVD-Video, but should be corrected if you use interlaced output.
Set "Video Output Mode" in Picture Menu to "480i" or "576i".
(Alternatively, press and hold [CANCEL] to switch to "480i" or
"576i".)
• Disable the HDMI AV OUT connection and use other video
connections. Make the settings in the following order:
1 Set "Video Mode" in the "HDMI" tab to "Off".
2 Set "Video Output Mode" in Picture Menu to "480i" or "576i".
(Alternatively, press and hold [CANCEL] to switch to "480i" or
"576i".)
• Select "480p" or "576p" in "Video Output Mode" in Picture Menu.
• The unit's SCART (AV) terminal outputs an interlaced signal even if
"PRG" is displayed.
• When HDMI or progressive output is on, closed captions will not be
displayed.
• Select "Bright" in "FL Dimmer" in the "Others" tab.
• You inserted a disc the unit cannot play; insert one it can.
• You inserted a blank disc.
• You inserted a disc that has not been fi nalized.
• You have not inserted a disc; insert one.
• You have not inserted the disc correctly; insert it correctly.
• Check and correct the speaker cable connections.
If this does not fi x the problem, consult the dealer.
• There is a power supply problem. Consult the dealer.
• Disc may be dirty. Wipe it clean.
• Incorrect operation performed. Read the instructions and try again.
• Trouble may have occurred. The numbers following "H" and "F"
depend on the status of the unit. Turn the unit off and then back on.
Alternatively, turn the unit off, disconnect the AC mains lead, and
then reconnect it.
• If the service numbers fail to clear, note the service number and
contact a qualifi ed service person.
• The HDMI connection acts unusually.
– The connected equipment is not HDMI-compatible.
– The HDMI cable is too long.
– The HDMI cable is damaged.
on the number being displayed ("1" or "2"), press and hold [ENTER]
and the corresponding numbered button ([1] or [2]) for at least 2
seconds.
Page
23
27
23
23
9
—
27
12
—
—
—
16
8
—
13
—
—
—
—
—
—
37
41
RQT8043