Yamaha ACD1 Service Manual page 44

ACD1
* Inspection using a compatible amplifi er
The following tests can be conducted using an amplifi er that can be connected to the ACD1.
■ When using an XP series, XM series or XH series amplifi er
ACD1 (REAR PANEL)
Connect any one of the REMOTE/MONITOR terminals 32 to 39 of the ACD1 to be tested to the REMOTE/MONITOR
terminal of the compatible amplifi er with a VGA cable.
• STANDBY Control Check ("2. Amp Control" → "Standby")
1. Press the [NEXT] key in the Home screen and then use the [ ▲ INC/YES]/[ ▼ DEC/NO] key to select "Amp Control"
category.
2. Press the [NEXT] key to move to the sub category of the "Amp Control".
3. Use the [ ▲ INC/YES]/[ ▼ DEC/NO] key to select "Standby".
4. Press the [NEXT] key to move to the "Amp ID".
5. Use the [ ▲ INC/YES]/[ ▼ DEC/NO] key to select the ID for the amplifi er for checking.
(Select the number of the REMOTE/MONITOR terminal to which the VGA cable is connected.)
6. Check that the POWER/STANDBY LED of the compatible amplifi er lights up in red.
7. Press the [BACK] key to move to the sub category of the "Amp Control" again.
44
2.AmpControl
å
Standby
2.AmpControl
Standby
å
Amp ID:
Standby
Compatible amplifier
XP series
XM series
XH series
32
å
VGA cable
MONITOR/REMOTE
terminal