Yamaha ACD1 Service Manual page 37

** Diag Mode **
Total Result [OK]
* 00 RESERVE-ACD1
01 SRAM
02 BATTERY
03 MAC ADDRESS
04 GPI
05 FAULT
06 RS485 SHEET
07 RS485 ALL
09 RTC
10 LCD
11 SW
12 D-SUB(32)
13 D-SUB(33)
14 D-SUB(34)
15 D-SUB(35)
16 D-SUB(36)
17 D-SUB(37)
18 D-SUB(38)
19 D-SUB(39)
20 ==> Category Menu
[Example of testing item selection list screen]
2-3. Exit from determination and execution screen of each test
Exiting the checking method and execution screen of each test (returning to Testing Item Selection List Screen) is illustrated
below by specifi c patterns.
(1) Visual check, semiautomatic check and measurement check
*** 10. LCD
Start LCD Test OK:[ENTER]
Back Light Test:
OK:[ENTER], NG:[0]
Full Dot Test:
OK:[ENTER], NG:[0]
[Visual check, semiautomatic check and measurement
check screen]
Exit is made using a key displayed on PC.
Pressing the [0] key forces the test to terminate, but NG will be displayed on the right side of the corresponding testing item. (This
indicates that the test is not completed yet.)
(2) Automatic check test
*** 01. SRAM
SRAM AddressBus OK!
SRAM DataBus
EXIT:[ENTER]
[Automatic check test screen]
After completion of a test under the automatic test items, test data may be displayed in addition to the OK/NG indication as a test
result. If the [ENTER] key is pressed on this screen, it will return to the testing item selection list screen.
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
***
***
OK!
ACD1
37