KEEWAY FACT 50 4T Maintenance Manual page 9

Loose cables threaten electrical safety. Check each cable
after it is clamped to another for electrical safety;
Wire clamps are not allowed to bend towards welding point;
Bind cables at the designated place;
Do not deploy cables at the end of frame or at sharp point;
Do not deploy cables at the end of bolts or screws;
Cable deployment shall be far from heat source and where
cables may be clamped during moving;
Cables along the handlebar shall be neither too tight nor too
loose, and do not interface with any neighboring parts at
steering positions;
Cables shall be properly deployed without twist or knot;
Check whether the connector jacket is damaged and whether
the connector is over-stretched before mounting connectors;
Adopt adhesive tape or hosepipe to protect cables if they are
positioned at sharp point or corner;
Bind cables with tape after repairing;
Control cables shall not be bent or twisted. Clumsy operation
may be caused in light of damaged control cables.
9