Cushman 622020-L Owner's Manual page 44

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Never operate the winch with less than five (5) full turns of cable around the drum. If the winch
motor stalls from overloading, do not continue to activate the winch remote control. The wire cable
may become overstressed.
4
Do not attempt to pull loads exceeding1500 lbs. (680 kg).
To pull out the cable, the free spool clutch knob must be used. Pull out and rotate the knob. If the
cable is under any load the clutch may not release easily. Jog out some of the cable to release the
tension and operate clutch. Pull out the desired amount of cable and secure. Engage the drum by
rotating the knob until it snaps in place. Never operate the winch unless the clutch is engaged.
Have all persons and pets leave the area while operating winch. Never allow anyone to remain in
the vehicle.
To prevent damage to the wire cable, never hook the cable to itself. Always use a nylon sling.
Stay clear of the winch, the cable and the cable hook. Place a heavy cloth, jacket or blanket over
the cable to act as a damper should the cable break when operating the winch.
4 - 12
Never Operate Winch with Less Than Five Turns Around Drum
Nylon
Sling
Use a Nylon Sling and Install a Damper when Winching
Damper