Manual Lift Bed; Electric Lift Bed Operation - Cushman 622020-L Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

MANUAL LIFT BED

Exercise caution while operating the manual lift bed to ensure the bed is not released during lifting
or lowering procedure. Severe injury could result if bed is released and traps fingers or other body
parts.
To lift the manual lift bed, pull back on the latch release handle immediately behind the driver seat. Raise the bed using
the handle on the side of the bed.
The gas strut will assist in raising the empty load bed and will keep the bed raised.
Over time, the gas strut may allow the load bed to slowly lower. If this condition is evident, replacement of gas strut is
required. To lower the manual lift bed, grasp the bed handle and lower the bed to the rest position. Be sure hands are
not trapped by the bed.

ELECTRIC LIFT BED OPERATION

Exercise caution while operating the electric lift bed to ensure clothing is not caught during lifting or
lowering procedure. Severe injury could result if bed is lowered and traps fingers or other body
parts.
The electric lift switch is located on the driver side of the front seat panel. Move the toggle switch lever up to raise the
load bed and down to lower.
Before operating load bed, check to ensure no one is behind the vehicle.
OPERATING PROCEDURES
Front of Vehicle
Manual Bed Latch
Electrical Bed Latch
Manual Load Bed Latch
Pull Up to Release
4
4 - 15