Wasp DELTA 2040 Use And Maintenance Manual page 20

PRINT TEST
Printing objects is really easy and does not require any particular precautions. The settings
described below can be followed also once and the maintenance can be checked after a con-
siderable time.
Spray some lacquer provided with the printer on the glass surface. In case of deliveries abroad
use the stick glue supplied with the printer.
WARNING
The lacquer must be sprayed on the glass surface, keeping it out of the printer to prevent da-
mages to the extruder and to the handling axis.
Make sure that the SD card with gcode has been inserted in the printer. In the provided card,
in the "gcode" folder there are some fi les which are ready to be printed.
From the LCD display select "menu_print from sd" and choose the desired fi le by pushing the
button.
The zero of the bed may sometimes need to
be adjusted so that the fi lament can stick cor-
rectly. Use external wheels "A" placed under
the printer bed.
For model 4070 the zero of the bed is adju-
sted by screwing/unscrewing the three screws
located near the extruder placement during
calibration, by menas of a screwdriver which
is not supplied.
At the end of the print collect the piece by
means of a palette knife which is not supplied.
FILE SETTING
Bring the printer up to temperature.
Push the button next to the dispaly.
In the menu which appears on the display select Prepare
by turning the button and pushing it.
According to the fi lament type, select the correct pre-heating
function (the ABS option is correct also for different fi laments
such as Nylon or Polystyrene).
Page 20
USE and MAINTENANCE MANUAL
A
Picture 14
A
A