Wasp DELTA 2040 Use And Maintenance Manual page 19

FILAMENT LOADING
In the printer side with the seat for the fi lament reel, a
small transparent tefl on tube "A" is located. Insert the
fi lament and push it until it goes out from the lower
part. Then place the reel inside the seat (see picture 10).
Open the printer front door and take thread "A", press
levers "B" of the fi lament puller and slide the thread
until it enters completely inside the dragging unit (see
picture 11).
Turn knob "C" and slide the thread through transparent tube "D" until it reaches the extruder
(see picture 12). Enable the heating, wait until the desired temperature is reached, turn knob
"C" and check that the material goes out from nozzle "E" (see picture 13).
C
D
Picture 12
Note: do not touch the printing head after the use because it could be overheated.
USE and MAINTENANCE MANUAL
Picture 10
Picture 11
E
Picture 13
A
A
B
Page 19