Table of Contents
Advertisement
Initializing the System for the first time
1. Set master override switch to off position.
2. Install four (4) AA batteries into the battery holder.
3. Install three (3) AAA batteries in the back of the remote
control.
Note the polarity of batteries and install them as indicated by the
silk screen (+/-) on the holder.
4. Connect AC Power (115 volts, 60 Hz) to fireplace.
Operating the System for the first time
5. Press SW1 button on the control module. The control module
will beep three (3) times and an amber LED is illuminated to
indicate that the IFC is ready to synchronize with a remote
control within 10 sec. Push the ON button. The control module
will "beep" four (4) times to indicate transmitter's command is
accepted.
The System is now initialized.
WARNING
Battery operated device. Read the battery instructions before installing them
into the system. Do not expose any battery, or its holder, or a device in which
batteries are installed, to a working temperature greater than 54°C / 129°F.
Figure 27c. Remote Control Battery Compartment
XG0218 - 160215
Operation
Temperature indication Display
With the system in the "Off" position, press the Thermostat Key
and the Mode Key at the same time. Look at the LCD screen on
the Remote Control to verify that a C or F is visible to the right of
the Room Temperature display.
Figure 27d. Remote Control display in Fahrenheit & Celsius.
Turn On the Fireplace
With the system Off, turn the master override switch to on
and press the On/Off Key on the Remote Control. The Remote
Control display will show some other active Icons on the screen.
At the same time the Control Module will activate the fireplace. A
.
single "beep" from the Control Module will confirm reception of
the command.
Turn Off the Fireplace
With the system On, press the On/Off Key on the Remote
Control. The Remote Control LCD display will only show the
room temperature. At the same time the Control Module will turn
off the fireplace. A single "beep" from the Receiver confirms
reception of the command.
Figure 27e. Remote Control Display
PL52DF* Indoor Gas Fireplace
Page 31
Advertisement
Table of Contents
