install the fuel joint cap. Otherwise, in-
jury could result from striking the fuel
joint accidentally.
1. Fuel hose
2. Fuel joint cap
6.
Hold the rear of the top cowling and fully
tilt the outboard motor up. Slightly lower
the outboard motor from the fully tilted
up position and fit the tilt support bar se-
curely into the holder located on the
clamp bracket.
1
2
1. Tilt support bar
2. Holder
EMU42951
Procedure for tilting down
F2.5A
1.
Slightly tilt the outboard motor up.
2.
Slowly tilt the outboard motor down
while pulling the tilt support lever up.
[EWM02412]
1
2
ZMU06753
ZMU06829
3.
Loosen the steering friction adjuster by
turning it counterclockwise, and adjust
the steering friction according to opera-
tor preference. WARNING! If there is
too much resistance it could be diffi-
cult to steer, which could result in an
accident.
[EWM00722]
F4B, F5A, F6C
1.
Slightly tilt the outboard motor up.
2.
Slowly tilt the outboard motor down
while pulling the tilt support bar up.
1. Tilt support bar
3.
Turn the steering friction adjuster coun-
terclockwise to set the steering friction
according
to
WARNING! If there is too much resis-
tance it could be difficult to steer,
which could result in an accident.
[EWM00722]
Operation
1
ZMU06833
operator
preference.
56