Turn the throttle grip from the fully closed
to the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
the throttle and shift cables.
F4B, F5A, F6C
Move the tiller handle fully to the left and
right to check that operation is smooth.
Turn the throttle grip from the fully closed
position to the fully open position. Check
that the throttle grip turns smoothly and
that it completely returns to the fully closed
position.
Check the throttle cable and throttle link for
loose or damaged connections.
Check the shift link and start-in-gear pro-
tection cable for loose or damaged con-
nections.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Clip
2. Engine shut-off cord (lanyard)
ZMU06851
EMU42861
Engine oil
F2.5A
1.
Put the outboard motor in an upright po-
sition (not tilted).
2.
Remove the top cowling.
3.
Check the oil level using the oil level
check window to be sure the level falls
between the upper and lower marks. Fill
with oil if it is below the lower mark, or
ZMU06852
drain to the specified level if it is above
the upper mark.
Operation
ZMU06874
1
2
ZMU06873
36