Yamaha F2.5A Owner's Manual page 50

Operation
6. After the engine starts, slowly return the
manual starter handle to the original po-
sition before releasing it.
7. Slowly return the throttle grip to the fully
closed position.
TIP:
 When the engine is cold, it needs to be
warmed up. For further information, see
page 47.
 If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and try
again. Also if the engine is warm and fails to
start, open the throttle a same amount and
try to start the engine again. If the engine
still fails to start, see page 82.
Procedure for starting outboard motor (F4B,
F5A, F6C)
1. Move the gear shift lever to the neutral
position.
45
1. Neutral position
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then, install the clip on the other
end of the cord to the engine shut-off
switch.
3. Align the engine start mark " " on the
throttle grip with the notch in the tiller
handle.
2
1. Start mark " "
2. Notch
1
ZMU06749
ZMU06744
1
ZMU06808