Kyocera FS-C2626MFP Service Manual page 130

Code Contents
3100 ISU home position error
The home position is not cor-
rect when the power is turned
on or at the start of copying
using the table.
3200 Exposure lamp error
The exposure lamp does not
turn on when power is on.
The lamp's lumosity does not
stabilize in one minute after
power is on.
Causes
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Home position sensor and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
ISU motor and main PWB (YC36)
Defective home Replace the home position sensor.
position sensor.
Defective ISU Replace the ISU motor.
motor.
Defective CCD Replace the scanner unit (see page 1-5-48).
PWB.
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-30).
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. LED PWB and LED driving PWB (YC2)
LED driving PWB (YC1) and CCD PWB
(YC3)
CCD PWB (YC1) and main PWB (YC8)
Defective LED Replace the scanner unit (see page 1-5-48).
PWB.
Defective LED Replace the scanner unit (see page 1-5-48).
driving PWB or
CCD PWB.
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-30).
1-4-16
Check procedures/
corrective measures
2M8/2M9