Other Settings (Options 2) - Sony RDR-HX780 Operating Instructions Manual

2
Set the Command Mode for the remote
so it matches the Command Mode for
the recorder you set above.
Follow the steps below to set the
Command Mode on the remote.
1 Hold down ENTER.
2 While holding down ENTER, enter
the Command Mode code number
using the number buttons.
3 Hold down both the number and
ENTER buttons at the same time for
more than three seconds.
z Hint
You can check the Command Mode for the
recorder in the front panel display (page 13).
When the Command Mode is set to "3 (Default
setting)," "1" or "2" does not appear.
DivX
Registration Code
Displays the registration code of DivX video
files for this recorder.
For more information, go to http://
www.divx.com/vod on the Internet.
Set Preview (HDD only)
Selects the thumbnail type shown in the Title
List.
Quick
Preview
Normal
110
Plays short excerpts from
throughout the selected
title.
Plays the selected title
from the beginning.
Other Settings
(Options 2)
You can make other operation settings.
USB
Restart USB Device
Restarts the connected USB device if it does
not respond to the recorder. If the connected
USB device still does not work properly, try
following:
– Turn the connected USB device off and on
again.
– Disconnect and then connect the USB
cable.
Confirm Printer
Displays the manufacturer and model name
of the printer connected to the recorder. Note
that this function may not work depending
on the printer.