Other Settings (Options) - Sony RDR-HX780 Operating Instructions Manual

b
Notes
• Some settings may not be available depending
on the connected device.
• When a DVI device is connected, you cannot
select "YCbCr 4:2:2" or "YCbCr 4:4:4."
• When "Screen Resolution" is set to "720 x 480i"
in the "HDMI Output" setup, you cannot select
"YCbCr 4:2:2."
Audio Output
Selects the type of audio signal output from
the HDMI OUT jack.
Auto Outputs Dolby Digital,
MPEG and DTS audio
signals as a bitstream
signal. Normally select
this position.
PCM Converts all audio
signals except for DTS
signals to PCM.
Bitstream Select this if the
Priority
connected device is
compatible with
bitstream audio.
b
Notes
• The PCM signals may not be output even when
you select "Auto" depending on the "Audio Out"
settings, number of audio channels, and the
HDMI-connected device.
• The "Audio Output" function is not available
when a DVI device is connected.
Control for HDMI
On Allows you to use the
"Control for HDMI"
function (page 20).
Off Turns off the function.

Other Settings (Options)

You can make other operation settings.
On Screen Display
On
Automatically displays
information on the screen
when the recorder is turned
on, etc.
Off Displays information only
when DISPLAY is
pressed.
Front Panel Display
Adjusts the lighting of the front panel
display.
On Bright lighting.
Off
Turns off the lighting and
saves power consumption
when the power is off.
Command Mode
Changes the Command Mode of the
recorder to avoid interference with your
other Sony DVD recorder or player.
1
Select a Command Mode ("1," "2," or
"3 (Default setting)"), and press
ENTER.
b
Note
The default command mode setting for this
recorder and the supplied remote is "3
(Default setting)."
The remote does not function if different
command modes are set for the recorder and
remote. Set the same command mode.
109
,continued