Indoor Unit Installation Drawings - Daikin FTXJ20MV1BW Installation Manual

Indoor Unit Installation Drawings

The mounting plate should be
installed on a wall which can
support the weight of the
indoor unit.
30mm or more
from ceiling
50mm or more
from walls
(on both sides)
Air filters
B
Filter frame
Tab
Claw
INTELLIGENT EYE sensor
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
■
English
A Mounting plate
G
Lower front panel
Service lid
The service lid is removable.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Air filter
How to attach the indoor unit
Hook the claws of the bottom
frame to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
Upper front panel
500mm
or more
Make sure that there are no obstacles within
500mm under the signal receiver.
adverse influence on the reception
performance of the receiver and the
reception distance may be shortened.
Front grille Bottom frame
* When dismounting the front grille, refer
to "Removing and installing the front grille"
on page 4.
INTELLIGENT EYE sensor
Caulk pipe hole
gap with putty.
Cut thermal insulation pipe
to an appropriate length and
wrap it with tape, making
sure that no gap is left in the
insulation pipe's cut line.
Wrap the insulation
pipe with the
finishing tape from
bottom to top.
C Wireless remote controller
Before screwing the
remote controller
holder to the wall,
make sure that
control signals are
properly received
by indoor unit.
D Remote controller
holder
A Mounting
plate
Clip
3