Installation Tips - Daikin FTXJ20MV1BW Installation Manual

Installation Tips

1.
Removing and installing the upper front panel
Removal method
1) Open the upper front panel.
2) Slide the front panel locks on the back of the front panel upward to release the locks (left and right sides).
3) Remove the panel shafts on both sides from the shaft holes, and dismount the upper front panel.
Back of the upper front panel
Front panel shaft
Shaft hole
Installation method
1) Slide the front panel locks on the back of the front panel upward to release the
locks (left and right sides).
2) Insert the panel shafts on both sides of the upper front panel into the shaft holes.
3) Slide the front panel locks on each side downward to lock them.
4) Close the upper panel.
5) Do NOT push on the front panel to close it.
6) Turn ON the unit by remocon. Wait till the panels are completely open. Then, turn
OFF the unit by remocon again.
7) Once the front panels close completely, gently push the upper front panel to hook
it into position.
2.
Removing and installing the front grille
• Removal method
1) Remove the upper front panel and air filters.
2) Remove the service lid. (Refer to the opening method on page 3.)
3) Disconnect the wire harnesses from the wire clamp, and remove the wire
harnesses from the connectors.
4) Push the lower front panel up until it stops.
5) Dismount the flap (large).
6) Open the 2 screw covers, and remove 4 screws from the front grille.
(The screw covers are not factory-mounted.)
Screw cover
• Opening method
Downward
4
3-2) Pull
3-1) Slide
Use a long flat plate such as a
ruler and wrap it in a cloth so
as not to damage the product.
Back of the upper front panel
2) Slide
Front panel lock
Flap (large)
The upper front panel does not
open any more than as shown in
the figure. Do not force it open
any further than that.
4)
5)
6)
7)
Wire clamp
Connectors
Wire harnesses
4 screws
Flap (small)
ON/OFF
■
English