Table of Contents
Advertisement
Setting Time from GPS on the Camera
The time information obtained from GPS signals can be set in the
camera. The margin of error is approx. ±0.02 sec.
If signals from at least five GPS satellites cannot be acquired, the time
cannot be auto updated. [Set now] will be grayed out and not selectable.
Even if [Set now] can be selected, updating the time may not be
possible due to an unfavorable timing of the GPS signal acquisition.
When [Auto time setting] is set to [Auto update], the date or time
cannot be manually set with [52: Date/Time/Zone].
If you use Wireless File Transmitter WFT-E8 (sold separately) or WFT-
E6 (sold separately) and do not want to change the time after
implementing [Sync time between cameras], set [Auto time setting] to
[Disable] in step 2.
Check the [GPS] setting.
1
Check that [GPS] is set to [Mode 1]
or [Mode 2].
Select [Auto time setting].
2
Select the desired setting.
3
Select [Auto update] or [Set now],
then press <0>.
[Auto update] updates the time when
the camera is turned on and a GPS
signal is received.
221
Advertisement
Table of Contents
