Heat Sink - HP EliteDesk 800 G2 Desktop Mini Maintenance And Service Manual

Heat sink

The heat sink is secured with four captive Torx screws.
1. Prepare the computer for disassembly
2. Remove the top cover
3. Remove the fan
4. In the order indicated on the heat sink, loosen the three captive Torx screws, and then lift the heat sink
out of the computer.
CAUTION:
sink.
CAUTION:
on the surface of the processor or the heat sink.
To replace the heat sink, reverse the removal procedures.
When replacing the heat sink, be sure to install thermal pads as shown in the following image:
(Top cover on page
(Fan on page 37).
Be sure the loosen the screws in the order indicated by the numbers stamped on the heat
To reduce a degradation in thermal performance, be sure not to touch the thermal grease
(Preparation for disassembly on page
21).
20).
Heat sink 43