Battery Installation And Removal - Motorola BASIC XTS 3000 User Manual

Battery Installation and Removal

DO NOT replace the battery in an area labeled "hazardous atmosphere."
If your radio is programmed with volatile-key retention (consult your
service technician), encryption keys will be retained for approximately
The battery is shipped uncharged, and must be charged before use.
Note
Refer to the "Battery Charging and Disposal" section on page 36.
Installing the Battery
1. Turn off the radio and hold it with the
back of the radio facing upward.
2. Insert the top edge of the battery into
the area at the top of the radio
between the radio's case and chassis.
Make sure the three tabs on the radio
chassis align with the three slots
under the top edge of the battery.
3. Rotate the battery toward the radio, and squeeze the battery and
radio together until the battery "clicks" in place.
Removing the Battery
1. Turn off the radio and hold it so that the
release button on the bottom of the battery
is facing upward.
2. Press downward on the release button so
that the battery disengages from the radio.
3. Remove the battery completely away from
the radio
! WARNING
To avoid a possible explosion:
DO NOT discard batteries in a fire.
CAUTION
!
30 seconds after battery removal.
Introduction
7