Advertisement
SET Up aND USagE iNSTRUCTiONS
q Unfolding the scooter for first time use.
1
Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and
inserting them into the T-tube.
Note: The joint lever is spring-
loaded and will automatically lock
in the upright position when fully
upright.
Note: The tension of the quick-
release lever can be adjusted by
tightening or loosening the allen
bolt. Be careful not to over-tighten.
You should always be able to open
and close the quick-release lever
by hand and the T-bar should slide
freely with the quick-release open.
2
Make certain BOTH handlebars
are properly locked onto the T-bar.
4
Depress the spring loaded button on the T-bar and insert into the exten-
sion tube. Turn the handlebar until the button aligns with the hole on the
extension tube and locks into place. To adjust the height of the handlebars,
open the quick-release lever and slide the T-bar to the desired position and
resecure the quick release lever to lock into place. If the T-bar is raised to the
maximum height, depress the push button located directly below the quick
release lever to lower the T-bar.
3
To release the folding
mechanism, put one foot on the
deck plate and push joint release
lever down. Raise handlebars up
until securely locked in the upright
position.
3
WaRNiNg: Failure to
properly secure the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and/or
fall. When properly secured, the
handlebars will not rotate and/
or move sideways. Note: When
properly secured, the spring-loaded
buttons will be clearly visible
through the holes on the T-tube.
WaRNiNg: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
WaRNiNg: Failure to
properly securethe quick-release
levermay cause the T-bar to slideup
or down while riding which may
cause you to lose control and fall.
Advertisement
