Toro Greensmaster eFlex 1800 Service Manual page 154

Preparing Reel for Grinding
NOTE: Before grinding a cutting reel, make sure that all
cutting unit components are in good condition. Depend-
ing on type of grinder used, faulty cutting unit compo-
nents can affect grinding results.
NOTE: When grinding, be careful to not overheat the
cutting reel blades. Remove small amounts of material
with each pass of the grinder.
1. Follow reel grinder manufacturer's instructions to
grind cutting reel to Toro specifications (see Reel Grind-
ing Specifications chart to the right). Additional reel
grinding information can be found in the Toro General
Service Training Book, Reel Mower Basics (part no.
09168SL).
2. After completing the reel grinding process, adjust
cutting unit (see Cutting Unit Operator's Manual).
Reel Diameter
Blade Land
Width
D1
Cutting Unit
Reel Grinding Specifications
Reel Diameter (New)
Service Limit - Reel
Diameter
Reel Shaft Diameter (OD)
Blade Relief Angle
Blade Relief Angle Range
Blade Land Width
Blade Land Width Range
Service Limit -
Reel Diameter Taper
Reel Diameter Taper = D1 -- D2
Figure 39
Page 6 - - 28
5.060 in (128.5 mm)
4.500 in (114.3 mm)
1.375 in (34.9 mm)
0.040 in (1.0 mm)
0.030 to 0.050 in (0.8 to 1.2 mm)
0.010 in (0.25 mm)
Blade Relief Angle
Rotation
Greensmaster eFlex 1800/2100
o
29
o o
27 to 31
D2