Table of Contents
Advertisement
Auto Setup
The Auto Setup function helps to configure your TV/DVD for initial
operation. It lets you select the system language, the TV signal type,
and perform an automatic channel search.
Important: Make sure that the antenna or cable TV system connection
is made.
Auto Setup
N
Press POWER on the unit or on the remote
control.
The POWER indicator on the front of the unit
changes to green. It may take approximately
10 seconds for a picture to appear on-screen.
POWER
O
The Auto Setup menu appears on screen.
"Language" is automatically highlighted. Press
or
P
Press
press
Air – VHF/UHF channels
Cable – Cable TV channels
Q
Press
then press
Downloaded from
www.Manualslib.com
POWER
to select your preferred language.
or
to select "Signal Type", then
or
to select "Air" or "Cable".
or
to select "Automatic Search",
or ENTER.
manuals search engine
R
The automatic channel search starts.
The TV/DVD will begin memorizing all the channels
available in your area.
If you want to stop the Automatic Search, press
EXIT/CANCEL. Only channels detected before the
cancellation will be stored.
After the Automatic Search is completed, the first
TV channel detected appears on the screen.
Notes:
• The Auto Setup function is only available the first time
you turn on the TV/DVD.
• The Automatic Search process may take 15 to 30
minutes to complete, depending on your regional
cable service.
POWER
ENTER
/ / /
EXIT/CANCEL
27
Hide quick links:
Advertisement
Table of Contents
