Wiring For Water Heater; Wiring Terminal Block For Remote Control - Toyotomi FB-38N Operation And Maintenance Instructions

(1) After making sure that the power supply cord is
disconnected, remove the two (2) screws from the
front panel and remove the front panel.
(2) Cut the rubber bushing on the left side panel by a
cutter and insert the remote control cord.
(3) Connect the terminal of the remote control cord to
the terminal block for the remote control on the
main circuit board case together with the terminal
wired from the circuit board.
(4) Fix the remote control cord on the cable clamp
located under the rubber bush. the main circuit
board.

WIRING TERMINAL BLOCK FOR REMOTE CONTROL

WIRING OF WATER HEATER
Main circuit board case
Transformer
Remote control cord
Terminal block
Connect the 2 (two) Y-terminals of the remote control cord on
the terminal block with the screws by putting on the terminals
of the lead wire (white) wired from the main circuit board.
Make sure that each terminals are contacted correctly.
14
Rubber bushing