When the water heater is malfunctioned, the unit stops the operation automatically and Display
indicates Error Code ("E" & "Number") alternately by flashing.
Display
E + 0
Disconnected model setting jumper terminal
E + 2
Flame sensor detected flame before ignition
E + 3
Disconnected thermistor
E + 4
High limit switch activated
E + 5
Tip-over switch activated
E + 6
Extinguished after ignition
E + 7
No ignition
E + 8
Blower motor malfunction
Heat exchanger bi-metal switch
E + 9
or Thermal fuse activated
E +
┣
Malfunction of remote controller or remote controller
E + Ξ
cord
–
E +
NOTE: To restart the unit, tunr the unit off by pressing "POWER SWITCH" and after 5 seconds
press "POWER SWITCH" to turn it on once again.
NOTE: Press the Reset Button of Heat Exchanger Bi-metal Switch to reset the unit when Heat
Exchanger Bi-metal Switch is activated. Make sure to disconnect the Power supply
cord before pressing the Reset Switch of Heat Exchanger Bi-metal Switch.
ERROR CODE IN DISPLAY
CAUSE
Out of fuel
Refuel
17
RESULT
Operation stops
and operation
lamp and display
are flashing.